We are proud to announce the release of our premium ball-bearing turbo kit with stainless steel exhaust housing for the F3x BMW platforms equipped with N55 EWG engine
 
We utilized transient flow analysis backed by flow bench testing to optimize turbine housing for a GTX3582R while maintaining stock fitment, stock location, and using the stock waste gate (this is not a stock turbo with a bigger compressor wheel). This allows to run any stock fitment exhaust downpipe, intake and charge pipe.
 
You can simply transfer your factory wastegate, your high performance downpipe, intake and charge pipe during the install.
 
Product Details:
Complete brand new turbocharger; no need for core to be sent it or purchased
GTX3582R-style Gen2 ceramic ball-bearing CHRA (dual ball-bearing)
Billet 10-blade compressor wheel
Proprietary stainless steel turbine housing, flow matched to the turbocharger
VSR Balanced to exceed OE tolerances
Oil and water fittings included
Compatible with factory installation hardware (not included)
Compatible with factory wastegate actuator (not included, use your original wastegate actuator. Actuator must be calibrated during installation. 90% WDC max)
 
Application guide (fitment for EWG electronic wastegate only):
F30 BMW 335i & 335xi (production date after 07/2013)
F32/F33/F36 BMW 435i & 435xi 2013+
 
**BIG TURBO SOFTWARE TUNING IS REQUIRED VIA ECUTEK PLATFORM, FUELING UPGRADES ARE RECOMMENDED. PROFESSIONAL INSTALLATION AND TUNING ARE REQUIRED.
 
WASTEGATE MUST BE CALIBRATED WITH ISTA+ BEFORE TUNING. FAILING TO DO THIS WILL CAUSE PROBLEMS WITH TUNING.
 
THIS TURBOCHARGER IS DESIGNED TO MOVE A LOT OF AIR AT FAIRLY LOW BOOST. MAX BOOST LEVEL IS 20PSI.
 
Dyno results below are from our friend and master tuner Jimmy, at TunedByJimmyB (IG: @tunedbyjimmyb)
 
Car:
2015 BMW 435i GC, Auto trans
 
Mods:
CTS Turbo N55 EWG BOSS turbo kit
CTS N55 intake
High-flow cat downpipe+FBO parts
High pressure fuel pump: Dorch Engineering Stage 2
Low pressure fuel pump: Single Walbro 274
Bosch EU5 S63 fuel injectors
TunedbyJimmyB custom DME+tranmission tuning, using EcuTek RaceRom
TunedbyJimmyB Flex Fuel Kit w/ Radium Engineering 6micron Fuel Filter
TunedbyJimmyB BPV delete plate – STRONGLY RECOMMENDED
491 whp and 484 ft/lb at 17psi on pump gas
580 whp and 546 ft/lb at 20psi on flex fuel (55% ethanol content)
Boost being brought in slowly, full boost by 5300rpm (to help prevent bending rods)